-
Mounting Method: Sandwich
-
Plate: 1.5mm thick
-
Typing angle: ~6.5 degrees
-
Mounting Hardware: 1/4" diameter thick brass standoffs, low-profile top screws, standard-profile bottom screws
-
Plate Materials: Stainless Steel, Brass, Copper, FR4. All shown in Material Options page
-
Metal Plate Finishes: Vibration, Sandblasted, Brushed. All shown in Material Options page
-
Built Weight: ~3.5 lbs / 1.6 kg (metal plate), ~2.5 lbs / 1.1 kg (FR4 plate)
PLATES
Metal plates cut and finished by the wonderful team at LaserBoost.
-------------------------------------------------------------------------------------------------
PCB
PCBs Designed and built by Mechlovin' Studio.
------------------------------------------------------------------------------------------------
FOAM
Alice style layout plate foam cut and provided by stupidfish designs.
Disclaimers:
Metal - All metal plates are uncoated and can potentially oxidize to form a patina over time. This can be further caused by water droplets (or other liquids), moisture, and oils from your hands or other sources. Stainless steel, brass, and copper can be affected differently from different types of contaminants. Patina has no adverse affects to the keyboard in general, simply an aesthetic difference. Steps can be taken to either remove patina and protect the plate through the use of a metal varnish. It is up to the customer to take the proper actions (if necessary) to protect the long-term finish of the plate of their keyboard.
Acrylic - Laser cutting acrylic can offer a very nice and clean edge finish to a design. However, there still may be some slight blemishes, specifically where the laser cutter engages in a new line. Other blemishes can still occur, but affected pieces will not be shipped if it is easily seen from the outside of the case.
Shipping calculated at checkout.
